Even though the process is fairly simple I found that it might take some time to get the hang of it. The longer the hosel of the club, the easier it will be to remove offset.
First you need to bend the loft of the club about 5 degrees weaker. This bend operation must be performed by placing the bending bar at the top of the hosel (where the shafts meets the hosel).
Then after that you need to perform a ‘regular’ bend operation, just above the clubhead. Bend the loft back to its original strength.
Now have a look and see if the amount of offset is less than before. You will probably have to repeat these steps a couple of times before you will get good results; but it will be well worth it in the end.
