Well, I took my clubs to the local club repair shop and asked them to bend to 6 degrees and was pretty much shown the door. “NFW”.
So, I contacted National Custom Works and they said, “6 degree flat heads? No problem.”
They asked a bunch of questions (“What weight do you want the head? Sole? Swing weight?”)
What specs should I give to get an ABS set? My Hogans are 2 deg flat, but the shafts were extended by 1/2” to accommodate. Is that normal?
Any help appreciated as far as general specs to give a fitter for the best outcome. Thx.
Here are John’s specs for how he sets up some of his clubs
John Erickson Club Specifications Steel X100 shafts tipped 1/2 inch
Club Weight Length Loft Lie
Driver 14 D 6 44 9 48
2 wood 14.5 D 6 43 12 49
1 iron 14.8 D 6 40 13 52
2 iron 15.2 D 6 39.5 16 52
3 iron 15.3 D 6 39 20 53
4 iron 15.4 D 6 38.5 24 54
5 iron 15.6 D 6 38 28 55
6 iron 16 D 6 37.5 32 56
7 iron 16.5 D 6 37 36 56
8 iron 16.7 D 6 36.5 40 57
9 iron 17 D 6 36 44 57
PW 17.8 E 4 35.5 50 58
Gap PW 18.0 E 5 35 53 58
SW 18.5 E 9 35 56 66
1 Like
That’s what I used for my two sets. That’s crazy. What is wrong with these shops. I’m going tomorrow to get my shafts tested for flex to make sure they are ok. Played first round of golf with 67 dynapowers and shot a smooth 47. A few 3 hacks didn’t help. Just happy to play again. Modules will have to seep in. It rained on us, hurricane winds and seeker shelter in Porto potties after they got rid of all shelters. Good luck with ur clubs sorry I decided to keep my hogans they are bent to those specs